Serving the mid-Willamette Valley · based in Lebanon, OR
Free Estimates · Call or Text (541) 936-4687
Willamette Valley Land ClearingForestry Mulching · Lebanon, Oregon
Our Services

Driveway and Access Road Clearing in Lebanon, OR

Driveway and Road Clearing · Lebanon, OR

Open the lane back to its full width

An overgrown driveway closes in a little more every season. Blackberry canes push out of the ditch, and alder and vine maple lean over the gravel. Our overgrown driveway and access road clearing opens the lane back to full width. We do this work across the mid-Willamette Valley from our base in Lebanon.

Our Bobcat skid steer carries a forestry mulcher head that grinds brush into chips where it stands. The excavator brush rake pulls the heavy root balls and the woody growth a mower cannot take. Where blackberry has taken the whole ditch line, the job runs with our blackberry removal work. Estimates are free, so call or text (541) 936-4687 and tell us how long the drive is.

What We Handle

  • Overgrown driveways and farm lanes opened back to full width
  • Brush and blackberry cut back from both edges of the lane
  • Low limbs and leaning brush cut back for overhead clearance
  • Sight lines opened where the drive meets the county road
  • Fence line clearing so a fence can be repaired or replaced
  • Gate approaches and turnouts cleared out
  • Access roads and right of way lanes reopened on back acreage
  • Brush mulched into chips in place or raked into a pile on site

Free Driveway and Road Clearing Quote

Tell us about the job. We will get right back to you.

Overgrown driveway clearing in the Lebanon and Sweet Home foothills

Lebanon sits where the valley floor meets the Cascade foothills. Sweet Home sits further up the South Santiam, between those foothills and the valley. Rural drives out here often run hundreds of feet off the county road. Some pass a gate and a turnout before they reach the house.

The growth that closes a lane in is predictable. Himalayan blackberry is the worst of it, and Oregon lists it as a noxious weed. Bigleaf maple sprouts back hard from the stump after a cut. Red alder fills the wet low spots, and vine maple crowds the shaded stretches.

We take the brush back to the edge of the lane and up off the surface. Where the lane has grown over the top, the mulcher head opens the ceiling as well. What comes off gets ground into chips, the same way our forestry mulching works on open ground.

Fence line clearing and right of way clearing

A fence line disappears under blackberry within a few seasons. Wire gets buried and the fence stops holding stock. We clear the line so the fence can be fixed or replaced. Building the fence itself is a job for a fence crew.

Right of way clearing runs the same way. A lane through back acreage or timber ground grows shut from both sides and from the top. We cut a clear running width and take the ceiling back over it. Where the line runs past a pole, a well head or a gate, we work around it.

Clearing the line makes the next pass easier. Once the heavy growth is gone, a lighter mow holds it. Some owners put their lanes and fence lines on a schedule with our brush hogging and field mowing.

Access road clearing for trucks, fire access and mud season

A rural drive has to carry more than a pickup. Gravel trucks, propane trucks, feed trucks and delivery rigs need width at the corners and room overhead. Fire access guidance for Linn and Benton counties typically calls for 20 feet of unobstructed width. It also calls for 13 feet 6 inches of clear height above the road.

A drive serving one or two homes can typically have a narrower driving surface. The cleared width still stays at 20 feet. A drive over 400 feet with a narrow surface typically needs turnouts. Your fire district sets what applies to your place, and we plan the cut around that.

Timing matters as well. Winters here are wet, and the ground under the gravel goes soft. Summer brings Oregon Department of Forestry fire season, which can limit power equipment hours. Oregon also typically calls for an 811 utility locate before ground disturbing work, and we plan for that.

Narrow gravel lane running into a conifer forest with brush and young trees crowding in on both sides Freshly mowed field with cut grass laid down, a split rail fence and a green treeline at the far edge

Ready to get started?

Free estimates across the mid-Willamette Valley.

(541) 936-4687
How We Work

How a Job With Willamette Valley Land Clearing Runs

From the first call or text to the final look at the cleared ground, here is how it goes.

1

Call or text us

Tell us where the property is and what you want cleared. Rough acreage and a couple of photos give us a good start.

2

Site visit and free estimate

We come out, look over the ground and talk through the scope with you. Then you get a free estimate for that scope of work.

3

Plan and timing

Before the machines move, we sort out access and timing. Oregon law typically calls for an 811 utility locate ahead of ground-disturbing work. In summer, Oregon Department of Forestry fire season rules can limit power equipment hours. We plan the job around whatever applies to your property.

4

The machine work

The mulcher head grinds brush and small trees into chips in place. The brush rake pulls stumps and root balls where the ground has to come clean.

5

Cleanup and final look

We spread the chips out and smooth the cleared ground where it needs it. Then we go over the finished work with you before we load up.

FAQ

Driveway and Road Clearing Questions, Answered

Common questions about driveway and road clearing across the mid-Willamette Valley. If yours is not here, call or text and ask.

Call (541) 936-4687

How wide will you open my driveway?
We cut back to the edge of the usable lane and take the ceiling up with it. Fire access guidance in Linn and Benton counties typically points at 20 feet of unobstructed width. Overhead, it points at 13 feet 6 inches. We set the target with you before the machines start.
Will the blackberry grow back along the driveway?
Some of it will. Blackberry canes root at the tips, and new canes come up from the root crown. Oregon field trials found canes cut to the ground averaged 41 inches tall a year later. Keeping the lane open means a repeat pass with the mower or the mulcher head.
Do you clear fence lines?
Yes. We take the brush and blackberry off both sides of the line and off the wire. That leaves a clear line to repair or rebuild on. The fence work itself goes to a fence contractor.
What happens to all the brush you cut?
Most of it gets mulched into chips and left along the lane. The chips break down and help hold the ground through the wet months. Where you want bare ground, the brush rake pushes the material into a pile in a spot you pick. We leave it on site, so haul off would be a separate outfit.
Do you rock or grade the driveway after you clear it?
We clear the brush and open the lane. Rock and grading are a separate trade, and an open lane gives that contractor room to work. Rough leveling of ground we have cleared can be part of the job. Ask when we look at the drive and we will scope it with you.
Can you clear around the house at the end of the drive?
Yes. Once the lane is open, we can cut fuels back around the house and the shop. That part of the work is our defensible space clearing. A whole parcel that has gone to brush runs as a land clearing job instead.
More From Willamette Valley Land Clearing

Work That Pairs With Driveway and Road Clearing

Skid steer working into a wall of thick green brush and undergrowth along a fence line

Brush Clearing

We clear thick brush, undergrowth and small trees off lots, field edges, fence lines and back acreage. The material gets mulched in place or raked into a pile.

Learn More
Dense Himalayan blackberry thicket climbing over the ground in front of a stand of conifers

Blackberry Removal

We clear Himalayan blackberry off fields, fence lines, yards and back acreage with mulcher heads. Blackberry regrows from its root crowns, so we plan the follow-up mowing with you.

Learn More
Open cleared ground with a dirt access track running into a standing green conifer forest

Lot Clearing

We clear homesites and building lots before construction starts. Brush, small trees and stumps come off the footprint and the access.

Learn More
Why Choose Willamette Valley Land Clearing

Land Clearing Done With the Right Machines

Mulcher heads on both machines

Our Bobcat skid steer carries a forestry mulcher head and a heavy brush mower. The excavator adds a mulching head and a brush rake, so stumps and root balls come out as we go.

Free estimates across the valley

Estimates are free in Linn, Benton, Marion, Polk and Lane counties. Tell us where the property sits and what you want cleared, and we will come look at it.

Overgrown to usable in one job

The same machines cut the growth, mulch the material and smooth the cleared ground. One company covers the work from the first pass to the last look.

Call or text to get moving

Reach us at (541) 936-4687 by call or by text. A few photos of the property help us size up the job before we drive out.

Free Estimates

Get In Touch With Willamette Valley Land Clearing

Tell us where the property is and what you want cleared, and we will set up a look at it. You can also call or text (541) 936-4687.

Get a Free Quote

Tell us about the job. We will get right back to you.